Ashcroft 205 - Diaphragm Seal Manuel d'utilisateur télécharger pdf

The 105/205 Saddle Seal is welded to the wall of a pipe as follows:

1.) A hole of the following diameter must be drilled in the pipe:

• For a 3˝ diameter pipe drill a 2

⁄

8˝ diameter hole.

• For a 4˝ diameter hole and larger pipe drill a 3˝ diameter hole.

2.) Remove upper housing of the seal from the lower housing

by removing (8) bolts. Use care so as not to damage the .004˝

thick diaphragm and Teflon gasket.

3.) Weld lower housing to the pipe as specified by the piping engineer.

Note: Excess heat from welding could distort the sealing surface

inside the lower housing. It is recommended a wet rag or

metal sink be placed against the sealing surface inside the

lower housing.

4.) Reassemble the top housing to the lower housing using the (8)

bolts removed in Step 2.

Note: Using a uniform cross tightening procedure, initially tighten

bolts finger tight, then 3 ft-lbs,

6 ft-lbs, and a final torque of 10 to 13 ft-lbs.

5.) A leak test of the piping system is recommended after assembly.

Tel: 203-378-8281 • www.ashcroft.com

All sales subject to standard terms and conditions of sale. I&M008-10183 6/10

Type 105/205 Saddle Seal

Installation Procedure

Résumé du contenu

Page 1 - Installation Procedure

The 105/205 Saddle Seal is welded to the wall of a pipe as follows:1.) A hole of the following diameter must be drilled in the pipe:• For a 3˝ diamete

Modèles reliés 105 - Diaphragm Seal

Commentaires sur ces manuels

Pas de commentaire

Ashcroft 205 - Diaphragm Seal Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Instruments de mesure Ashcroft 205 - Diaphragm Seal. Ashcroft 205 - Diaphragm Seal User Manual [fr] Manuel d'utilisatio

Résumé du contenu

Modèles reliés 105 - Diaphragm Seal

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Ashcroft 205 - Diaphragm Seal